Design of a Speed Sensorless Control System on a DC Motor using a PID Controller

Bernadeta Wuri Harini(1*), Theodore Galeno Gunadi(2), Shakuntala Gema Mahardika(3), Sirilus Praditya Pangestu(4), Regina Chelinia Erianda Putri(5), Stefan Mardikus(6),

(1) Sanata Dharma University
(2) Sanata Dharma University
(3) Sanata Dharma University
(4) Sanata Dharma University
(5) Sanata Dharma University
(6) Sanata Dharma University
(*) Corresponding Author

Abstract


The speed sensorless control system on a DC motor is a DC motor speed control system that does not use a speed sensor to measure the motor speed. The motor speed value is estimated by an observer from the stator current and voltage that are measured using a sensor. This study uses an R observer method.  The difference between the estimated speed and the reference speed is then used by the PID controller to adjust the motor speed to match the desired reference speed. PID parameter tuning using heuristic method. With a setpoint of 6800 RPM and using a combination of Kp = 0.5, Ki = 0.05, and Kd = 0.34, a speed value of 6792.76 RPM was obtained. Sensorless motor speed control using a PID controller produces an optimal system with a low Steady State Error (SSE) value of around 0.1%, very small oscillations of 0.39%, a fast rise time of 4 seconds, and a fast settling time of 6 seconds.


Full Text:

PDF

References


[1] P. Vas, Sensorless Vector and Direct Torque Control. Oxford University Press, 1998.

[2] A. Glumineau and J. de León Morales, Sensorless AC electric motor control. Springer, 2015.

[3] B. Wuri Harini, A. Subiantoro, and F. Yusivar, “Stability of the Rotor Flux Oriented Speed Sensorless Permanent Magnet Synchronous Motor Control,” IEEE Int. Symp. Ind. Electron., vol. 2018-June, pp. 283–289, 2018, doi: 10.1109/ISIE.2018.8433862.

[4] B. W. Harini, “The Effect of Motor Parameters on the Induction Motor Speed Sensorless Control System using Luenberger Observer,” vol. 4, no. 1, pp. 59–74, 2022.

[5] G. Tian, Y. Yan, W. Jun, Z. Y. Ru, and Z. X. Peng, “Rotor Position Estimation of Sensorless PMSM Based on Extented Kalman Filter,” 2018 IEEE Int. Conf. Mechatronics, Robot. Autom. ICMRA 2018, pp. 12–16, 2018, doi: 10.1109/ICMRA.2018.8490558.

[6] J. C. Gamazo-Real, E. Vázquez-Sánchez, and J. Gómez-Gil, “Position and speed control of brushless dc motors using sensorless techniques and application trends,” Sensors, vol. 10, no. 7, pp. 6901–6947, 2010, doi: 10.3390/s100706901.

[7] E. Engineering, U. Indonesia, and K. U. I. Depok, “Jurnal Teknologi A SYNCHRONIZATION LOSS DETECTION METHOD,” vol. 4, pp. 47–54, 2020.

[8] Bernadeta Wuri Harini, Martanto, and Tjendro, “Comparison of Two DC Motor Speed Observers on Sensorless Speed Control Systems,” J. Nas. Tek. Elektro dan Teknol. Inf., vol. 11, no. 4, pp. 267–273, 2022, doi: 10.22146/jnteti.v11i4.5019.

[9] K. Ogata, Teknik Kontrol Automatik. Jakarta: Erlangga, 1997.

[10] K. AL-MALIKI, Abdullah Y.; IQBAL, “FLC-based PID controller tuning for sensorless speed control of DC motor,” in 2018 IEEE International Conference on Industrial Technology (ICIT), 2018, pp. 169–174.

[11] F. Yusivar and S. Wakao, “Minimum requirements of motor vector control modeling and simulation utilizing C MEX S-function in MATLAB/SIMULINK,” Proc. Int. Conf. Power Electron. Drive Syst., vol. 1, pp. 315–321, 2001, doi: 10.1109/peds.2001.975333.

[12] M. Vidlak, L. Gorel, P. Makys, and M. Stano, “Sensorless speed control of brushed dc motor based at new current ripple component signal processing,” Energies, vol. 14, no. 17, 2021, doi: 10.3390/en14175359.

[13] S. B. Joseph, E. G. Dada, A. Abidemi, D. O. Oyewola, and B. M. Khammas, “Metaheuristic algorithms for PID controller parameters tuning: review, approaches and open problems,” Heliyon, vol. 8, no. 5, p. e09399, 2022, doi: 10.1016/j.heliyon.2022.e09399.

[14] Bernadeta Wuri Harini, “Pengaruh Parameter Motor pada Sistem Kendali tanpa Sensor Putaran,” J. Nas. Tek. Elektro dan Teknol. Inf., vol. 10, no. 3, pp. 236–242, 2021, doi: 10.22146/jnteti.v10i3.1848.




DOI: https://doi.org/10.24071/ijasst.v7i2.13271

Refbacks

  • There are currently no refbacks.









Publisher : Faculty of Science and Technology

Society/Institution : Sanata Dharma University

 

 

 

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.