Analisis Tegangan Roda Gigi Miring pada Transmisi Kendaraan Roda Empat berdasarkan AGMA dan ANSYS

Hadi Sutanto(1*),

(1) Program Studi Magister Teknik Mesin, Universitas Katolik Indonesia Atma Jaya
(*) Corresponding Author

Abstract


Two kinds of stresses in the gear teeth are root bending stress and tooth contact stress. These two stresses results in the failure of gear teeth. The root bending stress results in fatigue failure and contact stress results in pitting failure at the contact surface. The stress analysis used to minimize gear failure in the design of helical gear. It is also optimize the design of helical gear on the transmission system of the truck motor vehicle, where the power transmission is required at heavy loads with smoother and noiseless operation. In this paper bending stress and contact stress estimated using analytical method while modeling of gears used the numerical solution. Method of beam strength based on modified Lewis calculation used to predict the bending strength of helical gears. Contact stress was estimated using related method of AGMA contact stress. Stress modeling of helical gears is done by ANSYS 14.5, which is a finite element analysis package. The results are then compared with both AGMA and ANSYS procedures. The values of bending strength and contact stress determined using AGMA method found to be compatible with ANSYS simulation.

Full Text:

PDF

References


Norton, R.L. Machine Design: An Integrated Approach. Prentice Hall, Inc., New Jersey. 1996.

Dudley, D.W, Gear Handbook. 2 nd

edition, McGraw-Hill, Inc., NY. 1992.

Buckingham, E. Spur Gears. McGraw-Hill, Inc., NY.1962.

Tuplin, W.A. Gear Design. The Machinery Publishing Co., 1962.

Merritt, H.E. Gears. Pitman Publishing Co., 1964.

Vijayarangan, S. and Ganesan, N. A static analysis of composite helical gears using three-dimensional finite element method. Computers and Structures.1993; 49; 253-268.

Yi-Cheng Chen and Chung-Biau Tsay. Stress analysis of a helical gear set with localized bearing contact. Finite Element in Analysis and Design. 2002. 38. 707-723.

Moorthy, V. and Shaw, B.A. Contact fatigue performance of helical gears with surface coatings. Wear. 2012. 276-277.130-140.

Miryam B. Sanchez, Jose I. Prdrero and Miguel Pleguezuelos. Critical stress and load conditions for bending calculations of involute spur and helical gears. International Journal of Fatigue. 2013. 48. 28-38.

Seok-Chul Hwanga, Jin-hwan Lee, Dong-Hyung Lee, Seoang-Ho Hana and Kwon-Hee Lee. Contact stress analysis for a pair of mating gears. Mathematical and Computer Modeling. 2013. 57. 40-49.

Saarstahl Material Specification Sheet (http//www.saarstahl.com).

Kent L. Lawrence. ANSYS WorkBench. Tutorial Release 14. SDC Publications. 2013.




DOI: https://doi.org/10.24071/mt.v12i1.943

Refbacks

  • There are currently no refbacks.