Morphological Map Analysis in Design Cashew Sheller (Kacip) As a Creative Proccess to Produce Design Concept

Bertha Bintari Wahyujati(1*),

(1) PMSD
(*) Corresponding Author

Abstract


The design of cashew nut or cashew nut sheller uses appropriate or low technology with consideration of low cost for tool material. This pengkacip tool will be used at Ngudi Koyo, Imogiri, Bantul, Yogyakarta. Cashew shell peeler or cippling device as a result of the design is a modification of the existing cashew shell peeler. Some parts of the existing tool are applied to several modified parts, namely the lever mechanism, picking knife, or lever knife. This paper will discuss the method of selecting a suppressor, lever and picking system on a tool using the morphological map analysis method. Morphological maps will produce alternative designs for cashew nut peeler. The selection of alternative designs will be carried out by analyzing the results of testing in a technical mechanism, material strength, and alternative design quality values. Testing of alternative technical systems mechanisms is done by comparing the mechanical systems of existing tools. The size of the tool uses the anthropometric measurements of the female operator's body, because the operators in the Ngudi Koyo UKM are all women. The tool size adjustment will provide work comfort and increase efficiency. Quality testing in addition to using standard anthropometric standards, will be tested for quality of ease of care, ease of transferring, clean, neat, simple and safe tool.Key words: Effective technology , low technology tool, security, Design Alternative Testing

Full Text:

PDF

References


Awaludin, Dace. 1995. Modifikasi dan uji performansi alat pengupas kulit buah mete. Fakultas Teknologi Pertanian. Institut Pertanian Bogor. Bogor.

Direktorat Jendral Perkebunan. 1989. Pedoman Pelaksanaan Pengembangan Jambu Mete. Departemen Pertanian. Jakarta.

Wibowo. Mohamad Saldin , Modifikasi Dan Uji Performansi Alat Pengupas Kulit Buah Mete Gelondong, Departemen Teknik Mesin Dan Biosistem Fakultas Teknologi Pertanian Institut Pertanian Bogor,2011

Cross, Nigel., Engineering Design Methods, Wiley, UK,2000

Lutters,Eric.,Van Houten,Ferd JAM.,Bernard ,Alain.,Et all.,Tools and Techniques for Product Design, Elsevier Journals, 2014

Kabupaten Bantul Dalam Angka, 2018, CV. Lunar Media Sejahtera, ISSN: 0215 5184

Safri Ramadhan, Haniza, Ergonomic Facility Design on Station CV Putra Darma Sorting,JIME, Vol. 1(1) Mei (2017) p-ISSN : 2549-6328 e-ISSN : 2549-6336

Wigjosoebroto, Sritomo; Sutaji, artikel prosiding Seminar Nasional Ergonomi , Teknik Industri FTI-ITS,Surabaya, 2000




DOI: https://doi.org/10.24071/ijasst.v1i2.1916

Refbacks

  • There are currently no refbacks.









Publisher : Faculty of Science and Technology

Society/Institution : Sanata Dharma University

 

 

 

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.